قالب وردپرس درنا توس
Home / Tips and Tricks / Spilled water on your laptop? Here's how to fix it

Spilled water on your laptop? Here's how to fix it



  What to do if you spilled water on your laptop gaming laptop01
JodiJacobson / GettyImages

So you've played something on your laptop. Whether you're putting your glass too close to your computer or using it to play music at a party and your Elaine dance didn't go as planned, you might want to read this article frantically on your phone while trying to figure out how to save your valuable laptop. computer from the liquid you just spilled on it.

It is important to note that if your laptop becomes wet, the time is the core. You must turn it off, unplug it, and remove the battery immediately . Every second counts. Do not disturb to take the correct steps to turn it off either ̵

1; continue and press the power button until your machine turns off. If you haven't done so yet, stop reading and doing so before continuing with our tutorial below. Disconnect the mouse and cables and remove any flash drives and DVDs. Leave your laptop naked.

Step 2: Wipe the outside of your machine. Open your laptop as far as it goes, hold it upside down and wipe off any wet surfaces you see with a towel or other lint-free absorbent fabric. Type of Liquid Substances: Water is the least corrosive, while sweet and alcoholic liquids are the most harmful. In any case, the goal is to mitigate their effects as much as possible by wiping the computer immediately.

Step 3: At this point, we recommend that you use the warranty if it is still applicable, or take your machine to a workshop.

If you don't want a professional, take a look at it for you, but there are some steps you can take to try to wipe the machine out. Note, however, that neither Digital Trends nor the author accepts any liability for damages caused by your machine from taking it apart.

Break it down

While laptops for years made the process of opening them and removing components easy, that's not really the case with modern laptops. We would not recommend doing much for them unless your process makes it relatively painless, as it is easy to damage a laptop by taking it apart and the last thing we want to do is to make the situation worse. That being said, here are some steps you can take if your laptop allows it.

Step 1: If you don't already have it and your laptop allows it, remove the battery. This can usually be achieved by pressing a button or button on the bottom of your laptop.

Step 2: If you are concerned that fluid leaks through the entire system, to components such as your memory and storage device, you can also remove them. In some laptops you will find panels that allow removal on the underside. However, in most cases, you must use a Phillips screwdriver to remove them. With the memory, press the side clip to eject each pin. With the solid state or hard drive, you probably need to undo more screws to release it from the frame. Be sure to carefully remove it from the power ports or cables.

Step 3: Examine each component you have removed to check any signs of wetness or corrosion. Some wet parts should be dried, but if the liquid is anything other than water, you want to wipe it off (you can use a cotton swab) with 99 percent isopropyl alcohol – this will dissolve the gunk without damaging and dimming without leaving the residue.

Step 4: When finished, you want to leave everything alone to air dry for two to three days in a warm and dry area. Remember that a fan will speed up the drying process. Do not use a hair dryer as it may cause static problems. Once you have selected your machine from each other and allowed the components to dry, you can follow the instructions reverse to put your laptop back and see if it works.

Hopefully everything will be fine, but if not you "I want to take it to a repair center.

If your laptop cannot be taken apart

What if you have a Surface Book 2 or MacBook or any other laptop that refuses to be taken apart? This situation drastically reduces your possibilities, so you have to take it to a repair center.

Between the time liquid is spilled on the keyboard and the time you take to the store, here's what you can do: Keep your machine upside down, wipe any visible wetness with a towel.

Then lay it down on a dry surface.A great option is a large bag of rice because rice is sufficiently absorbent to help pull out fluid that makes it its way inside the slots on your keyboard, use a large bag, lots of rice and place everything in a warm, dry room, please turn on a fan to speed up the process In the time when you can carry your laptop to a repair shop.

Waterproofing options

To protect your laptop in the future, we recommend that you invest in a silicone or clear plastic keyboard cover, a waterproof portable computer case for the upper and lower halves of the case and a waterproof portable screen protector . You can also carry your laptop around in a good portable bag. Be careful not to cover any ventilation holes, and use a pair of scissors to cut the skin if necessary to ensure that your ventilation holes are free.

Digital Trends can earn a commission on products purchased through our links, which supports the work we do for our readers.






Source link